.jpg)
Restoring a pool using a pressure washer involves a number of steps, including cleaning the pool surface, removing stains, and addressing any structural issues. Here is a general guide on how to use a pressure washer to restore a pool:
1. Remove all debris, such as leaves and twigs, from the pool using a skimmer or pool net.
2. Drain the water level to a level that is comfortable to work with, usually a little above the tile line.
3. Test the pH and chlorine levels and adjust as necessary to ensure the pool is safe for cleaning.
4. Put on personal protective equipment, including eye and ear protection, slip-resistant footwear and gloves.
5. Apply a mild detergent or pool surface cleaner to the pool surface and allow it to sit for a few minutes.
6. Use a pressure washer with a low-pressure nozzle and a wide spray pattern to gently wash the pool surface and remove dirt and stains.
7. Use a medium-pressure nozzle to clean away tougher stains and mildew from tile lines, surfaces and concrete surfaces.
8. Make sure the pressure washer is not too close to the surface to avoid damaging the surface.
9. Rinse the pool surface thoroughly with clean water to remove any remaining detergent or cleaning solution.
10. Inspect the pool for any structural issues, such as leaks or cracks, and address them as necessary.
11.Refill the pool with water and adjust the pH and chlorine levels as necessary.
12. Turn on the filtration system and let it run for 24 hours.
It's important to be familiar with the type of pool surface and any specific cleaning needs, as certain types of surfaces may require different pressure settings or cleaning solutions. Consult your pool .
